Turn the rings around the feet by hand until both feet are firmly in contact with the floor. Once in position, adjust the front feet of the appliance to make sure it’s level. Take care not to upset any water connections or tangle the mains lead. Tilt the refrigerator backwards and use the wheels at the rear base to position the appliance. After this period, you’re ready to plug the appliance in, switch it on at the mains and move it into position. Make sure to let at least 4 or 5 big glasses of water to run through the appliance before you start drinking from the water dispenser.īefore you plug in your appliance and switch it on at the mains, wait at least 4 hours for the compressor gas and liquid to settle.

If you do notice a leak, turn off the water supply and tighten all the connections, wipe away leakage, then turn the water supply on again to check. Turn the water supply on and check for any leaks. Connect these to the water supply tap and the appliance as described above. Two water hoses will be running from either end of the filter. Once the brackets are installed, clip the filter into position. Note that the filter must be installed in an upright position. Once you’ve identified a position, you can affix the mounting brackets provided with your appliance to the wall. Note that the filter must not be mounted to the appliance. Once your fridge is ready to dispense water, fill a glass at least 4 or 5 times and pour the water out before drinking from the dispenser.įirst, you’ll need to identify a position where you can mount the filter to a wall. Remove the tank and give it a rinse under the tap before using it. Consult your user manual and find your fridge’s water tank. Water tanks are usually inside fridge doors and are removable. If your refrigerator is not a plumbed model, it must have a water tank to pull water from. Non-plumbed refrigerators with water dispenser If you’ve followed the steps on our refrigerator installation guide, you’re ready to move on with the water connections. Plumbed models need to be connected to a water supply to operate. Tanked models have a plastic or glass water tank inside the door for water storage. Water supply hose, water filter, fixings (for plumbed models)īefore using your refrigerator’s water dispenser, you need to figure out if it’s a tanked (non-plumbed) or a plumbed model.

Instaling Beku